TSEA82 · 4 credits · Basic level (G1F) · Datateknik, Elektroteknik
Computer Hardware and Architecture
Active · next start VT 2027
100%
passed the latest regular sitting
LAB1 · 3 Jun 2025 · 75 students
100%
passed the regular sittings, all sittings over the last 5 years
LAB1 · 288 students
This module only reports passing results, so the pass rate does not show how many did not pass.
Part of 1 programme
Hand-in or lab
LAB1 Laboratory work
- G
Main rounds
100% passed · 288 students
- 100%75
- 100%76
- 100%66
- 100%71
Later rounds
100% passed · 37 students
- 100%7
- 100%11
- 100%8
- 100%11
- Pass a later round: 100% (37 students), compared with 100% (288 students) on the ordinary exam
Show small sittings (18)
Sittings with fewer than 5 students, often credit transfers or special sittings. They are not part of any figure on this page.
- 100%2
- 100%1
- 100%2
- 100%1
- 100%1
- 100%1
- 100%2
- 100%2
- 100%1
- 100%2
- 100%1
- 100%1
- 100%3
- 100%1
- 100%1
- 100%1
- 100%1
- 100%4
Other modules
Partial exams, hand-ins and labs. They are not part of the figures at the top.
Hand-in or lab
LAB2 Laboratory work
- G
Main rounds
100% passed · 86 students
- 100%86
Later rounds
100% passed · 7 students
- 100%7
- Pass a later round: 100% (7 students), compared with 100% (86 students) on the ordinary exam
Show small sittings (1)
Sittings with fewer than 5 students, often credit transfers or special sittings. They are not part of any figure on this page.
- 100%1
Hand-in or lab
LAB3 Laboratory work examination
- G
Main rounds
100% passed · 69 students
- 100%69
Later rounds
No sittings with at least 5 students.
Show small sittings (2)
Sittings with fewer than 5 students, often credit transfers or special sittings. They are not part of any figure on this page.
- 100%3
- 100%1
About the course
Aim
The course provides a technical base on how simple processors work and are programmed at the lowest level. The laboratory work will through experimental implementation of a computer system provide practical knowledge in applying abstract models and troubleshooting methodology. Data sheets and manuals practice reading technical literature. After a completed course the student shall be able to:
- Program a processor at assembly level
- Use a processor in an embedded system
Content
- Binary arithmetic:Number representations, integers and floating point numbers. Arithmetic-logic operations, addition, subtraction, multiplication, shift.
- Assembly programming:Instructions, addressing modes, interrupt. A/D-conversion.
- Computer architecture:Internal data flow in a simple computer model. Instructions,addressing modes, input and output, interrupts.
- Micro controller:Purpose and characteristics. Built-in functions, timer, clock options.
- Examiner
- Anders Nilsson
- Scheduled hours
- 34 h
- Main field of study
- Datateknik, Elektroteknik