TMHP51 · 6 credits · Advanced level (A1N) · Elektroteknik, Maskinteknik
Hydraulic Servo Systems
Active · next start HT 2026
92%
passed the latest ordinary exam
TEN3 · 17 Jan 2026 · 25 students
94%
passed the ordinary exams, all sittings over the last 5 years
TEN3 · 156 students
27%
Harder than 27% of courses at advanced level
Compared with 285 courses at the same level, ordinary exams over the last three academic years. 60 students.
Part of 2 programmes
Exam
TEN3 Written examination
- 5
- 4
- 3
- U
Ordinary exams
94% passed · 156 students
- 92%25
- 94%35
- 88%24
- 100%31
- 93%41
Re-exams
100% passed · 5 students
- 100%5
- Pass the re-exam: 100% (5 students), compared with 94% (156 students) on the ordinary exam
- Get 4 or 5: 58% (161 students)
Show small sittings (11)
Sittings with fewer than 5 students, often credit transfers or special sittings. They are not part of any figure on this page.
- 33%3
- 100%1
- 33%3
- 100%1
- 50%4
- 100%1
- 100%4
- 100%2
- 50%2
- 100%1
- 75%4
Other modules
Partial exams, hand-ins and labs. They are not part of the figures at the top.
Hand-in or lab
LAB3 Laboratory work
- G
Main rounds
100% passed · 97 students
- 100%29
- 100%42
- 100%26
Later rounds
100% passed · 78 students
- 100%34
- 100%44
- Pass a later round: 100% (78 students), compared with 100% (97 students) on the ordinary exam
Hand-in or lab
UPG2 Hand-in assignment
- G
Main rounds
100% passed · 171 students
- 100%29
- 100%40
- 100%26
- 100%33
- 100%43
Later rounds
No sittings with at least 5 students.
Show small sittings (3)
Sittings with fewer than 5 students, often credit transfers or special sittings. They are not part of any figure on this page.
- 100%1
- 100%1
- 100%2
About the course
Aim
After completing the course, the student should be able to:
- Explain dynamic phenomena that can occur in hydraulic systems and describe the functional principles and characteristics of common components.
- Formulate and analyze dynamic models for systems and components in the time and frequency domains, as well as systematically design controllers based on system requirements.
- Use appropriate simulation tools and be able to present analyses and conclusions in writing.
- Perform relevant measurements and analyze experimental data.
Content
In this course, the focus is on the dynamic aspects of hydraulic systems. It addresses common phenomena that may occur, valve technology, dynamic modeling of hydraulic systems/components/loads, system analysis in the time and frequency domains, as well as methods for controlling hydraulic systems.
The course is based on lectures where the main content and theory are presented, as well as lessons with exercises. Parts of the course content are also tested through computer simulations and practical laboratory work.
- Examiner
- Samuel Kärnell
- Scheduled hours
- 54 h
- Main field of study
- Elektroteknik, Maskinteknik